End result
Step 1:
Step 2(Part 2):
Step 1:
Cut up plastic and apply glue onto the containers
Step 2:
Step 2(Part 2):
Step 1:
As shown in the picture above, plastic from the plastic bag is glued onto the container to create water resistance.
Step 2(Part 2):
Step 2(Part 2):
Demonstration of how it looked like halfway through the process
This is how the container looked like on the outside. plastic was glued here too. A few layers of plastic was applied to improve water resistance.
Demonstration of how it looked like halfway through the process
Demonstration of how it looked like halfway through the process
Demonstration of how it looked like halfway through the process
This is what the container is supposed to look like through the process.
End result
Demonstration of how it looked like halfway through the process
End result (Part 2):
This is what the container should look like on the outside
End result (Part 2):
Demonstration of how it looked like halfway through the process
End result (Part 2):
This is what the inside of the container should look like. As you can see, I used scotch tape inside the container to make sure that the glued-up plastic is intact and proper, but using masking tape is better as it is stronger and can hold the plastic together better.